| SPR-10 |
The [spacecraft] shall protect authenticator content from unauthorized disclosure and modification.{SV-AC-1,SV-AC-3}{AC-17(6),CM-3(6),IA-5,IA-5(6),RA-5(4),SA-8(18),SA-8(19),SC-28(3)}
|
Authenticators (keys, tokens, counters, certificates) are primary targets for persistent access attacks. Disclosure or modification enables command spoofing, replay, and privilege escalation. Protecting authenticator content preserves command integrity and prevents adversaries from maintaining covert control. Integrity protections must apply both at rest and in use.
|
| SPR-19 |
The [spacecraft] shall encrypt all telemetry on downlink regardless of operating mode to protect current state of spacecraft.{SV-CF-4}{AC-3(10),RA-5(4),SA-8(18),SA-8(19),SC-8,SC-8(1),SC-13}
|
Telemetry exposes real-time spacecraft state and configuration. Unencrypted telemetry can reveal vulnerabilities, operational status, or targeting information. Enforcing encryption across all modes prevents intelligence collection and mission state inference. This mitigates passive RF interception threats.
|
| SPR-33 |
The [spacecraft] shall utilize TRANSEC. TRANSEC shall be implemented and verified as a distinct layer in coordination with Traffic Flow Security and RF anti‑fingerprinting.{SV-AV-1}{CP-8,RA-5(4),SA-8(18),SA-8(19),SC-8(1),SC-8(4),SC-16,SC-16(1),SC-16(2),SC-16(3),SC-40,SC-40(4)}
|
Transmission Security (TRANSEC) is used to ensure the availability of transmissions and limit intelligence collection from the transmissions. TRANSEC is secured through burst encoding, frequency hopping, or spread spectrum methods where the required pseudorandom sequence generation is controlled by a cryptographic algorithm and key. Such keys are known as transmission security keys (TSK). The objectives of transmission security are low probability of interception (LPI), low probability of detection (LPD), and antijam which means resistance to jamming (EPM or ECCM).
|
| SPR-37 |
The [spacecraft] shall protect system components, associated data communications, and communication buses in accordance with: (i) national emissions and TEMPEST policies and procedures, and (ii) the security category or sensitivity of the transmitted information, and shall demonstrate compliance via pre‑launch TEMPEST‑like evaluation for co‑located payload configurations.{SV-CF-2,SV-MA-2}{PE-14,PE-19,PE-19(1),RA-5(4),SA-8(18),SA-8(19),SC-8(1)}
|
The measures taken to protect against compromising emanations must be in accordance with DODD S-5200.19, or superseding requirements. The concerns addressed by this control during operation are emanations leakage between multiple payloads within a single space platform, and between payloads and the bus.
|
| SPR-38 |
The [spacecraft] shall be designed so that it protects itself from information leakage due to electromagnetic signals emanations.{SV-CF-2,SV-MA-2}{PE-19,PE-19(1),RA-5(4),SA-8(19)}
|
This requirement applies if system components are being designed to address EMSEC and the measures taken to protect against compromising emanations must be in accordance with DODD S-5200.19, or superseding requirements.
|
| SPR-64 |
The [spacecraft] shall detect and deny unauthorized outgoing communications posing a threat to the spacecraft.{SV-DCO-1}{IR-4,IR-4(1),RA-5(4),RA-10,SC-7(9),SC-7(10),SI-4,SI-4(1),SI-4(4),SI-4(7),SI-4(11),SI-4(13),SI-4(24),SI-4(25)}
|
Outbound communications may indicate data exfiltration, covert channels, or compromised subsystem behavior. Monitoring and blocking unauthorized egress prevents leakage of mission data or cryptographic material. Many attacks rely on command-and-control or data extraction channels; egress control disrupts this persistence mechanism. Outbound traffic should be as tightly controlled as inbound command paths.
|
| SPR-182 |
The [spacecraft] shall generate error messages that provide information necessary for corrective actions without revealing information that could be exploited by adversaries.{SV-AV-5,SV-AV-6,SV-AV-7}{RA-5(4),SI-4(12),SI-11}
|
Error outputs must enable corrective action without exposing system internals. Detailed diagnostic data may aid adversarial reconnaissance. Sanitized messages protect confidentiality while supporting recovery. Controlled verbosity reduces exploitation opportunities.
|
| SPR-183 |
The [spacecraft] shall reveal error messages only to operations personnel monitoring the telemetry.{SV-AV-5,SV-AV-6,SV-AV-7}{RA-5(4),SI-4(12),SI-11}
|
Limiting error visibility prevents information leakage to unauthorized entities. Adversaries often probe systems to extract internal states via fault responses. Controlled telemetry channels ensure only trusted operators receive diagnostic information. This preserves operational awareness without expanding exposure.
|
| SPR-229 |
The [organization] shall protect documentation and Controlled Unclassified Information (CUI) as required, in accordance with the risk management strategy.{SV-CF-3,SV-SP-4,SV-SP-10}{AC-3,CM-12,CP-2,PM-17,RA-5(4),SA-3,SA-3(1),SA-5,SA-10,SC-8(1),SC-28(3),SI-12}
|
Documentation may reveal architecture details exploitable by adversaries. Proper handling prevents leakage. Protection of CUI supports regulatory compliance. Information governance complements technical controls.
|
| SPR-230 |
The [organization] shall identify and properly classify mission sensitive design/operations information and access control shall be applied in accordance with classification guides and applicable federal laws, Executive Orders, directives, policies, regulations, and standards.{SV-CF-3,SV-AV-5}{AC-3,CM-12,CP-2,PM-17,RA-5(4),SA-3,SA-3(1),SA-5,SA-8(19),SC-8(1),SC-28(3),SI-12}
|
* Mission sensitive information should be classified as Controlled Unclassified Information (CUI) or formally known as Sensitive but Unclassified. Ideally these artifacts would be rated SECRET or higher and stored on classified networks. Mission sensitive information can typically include a wide range of candidate material: the functional and performance specifications, the RF ICDs, databases, scripts, simulation and rehearsal results/reports, descriptions of uplink protection including any disabling/bypass features, failure/anomaly resolution, and any other sensitive information related to architecture, software, and flight/ground /mission operations. This could all need protection at the appropriate level (e.g., unclassified, SBU, classified, etc.) to mitigate levels of cyber intrusions that may be conducted against the project’s networks. Stand-alone systems and/or separate database encryption may be needed with controlled access and on-going Configuration Management to ensure changes in command procedures and critical database areas are tracked, controlled, and fully tested to avoid loss of science or the entire mission.
|
| SPR-244 |
The [organization] shall define the secure communication protocols to be used within the mission in accordance with applicable federal laws, Executive Orders, directives, policies, regulations, and standards.{SV-AC-7,SV-CF-1}{PL-7,RA-5(4),SA-4(9),SA-8(18),SA-8(19),SC-8(1),SC-16(3),SC-40(4),SI-12}
|
Standardized secure protocols reduce interoperability risk. Alignment with federal standards ensures validated cryptography. Defined protocols prevent ad hoc insecure implementations. Governance strengthens communication assurance.
|